Sane should work with that scanner judging from a few hits I saw searching google. Here's a thread from sane-devel: http://www.mostang.com/pipermail/sane-devel/2003-February/017856.html > I have an epson perfection 1260 attached but I never even tried to get it to > work. I think that the Epson would have more documented support than the > handspring, so I think I will get that going first then that may shed some > light on my USB situation. > > Stay tuned for details. > > anthony > > On Monday 28 April 2003 06:52 pm, Kevin Brown thought they were smart and > wrote: > >>Is anything attached to the USB ports? I think those files are created >>dynamically when devices are attached. >> >> >>>It appears that my /dev/usb holds no devices. My USB controller is >>>detected and installed. My (built-in) USB hub is detected but not >>>installed so I have nothing to link to. Hmmm. This is going to take more >>>work that I had anticipated. I will work on it and get back with y'all. >>> >>>anthony >>> >>>On Monday 28 April 2003 12:38 pm, Alan Dayley thought they were smart and >>> >>>wrote: >>> >>>>I point /dev/pilot to /dev/ttyUSB1. Don't forget to check the permission >>>>settings on both ttyUSB0 and ttyUSB1. I don't quite understand how it >>>>works but syncing a palm device uses both of those ports. >>>> >>>>Alan >>>> >>>>-------Original Message------- >>>>From: tickticker >>>>Sent: 04/28/03 08:15 AM >>>>To: plug-discuss@lists.plug.phoenix.az.us >>>>Subject: /dev/pilot and Evolution >>>> >>>> >>>>>Hello everyone, >>>> >>>>I recent came into posession of a handspring treo, and want to sync it >>>>with >>>>Evolution. I get an erro that /dev/pilot should pointot a usb serial >>>>port. >>>>Which port do I symlink to /dev/pilot?