On Thu, 2004-06-17 at 18:24, Michael Havens wrote:
> Well, my tweeking succeeded in changing most of the setting (it didn't like 
> 'stopbits') so I had to manually put the one it didn't like in. But now what 
> do I do? I open minicom and nothing  happens. I've tried ttyS0 and ttyS1 yet 
> still nothing happens. I even looked in minicom.cap to see if it put anything 
> in there; that was to no avail!

minicom must be set to 9600bps, with 8-N-1.  Then, you must plug in a
Cisco console cable and power up the switch.

Dorian already mentioned that these cables are available:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=3704&item=5704841424

Or, you can make one:
http://www.kame.net/~suz/cisco-cable.html

With all that in place, you should see the boot screen appear when you
power up the switch.

...Kevin

---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss