On Wed, 2005-02-09 at 13:39 -0700, der.hans wrote:
> Am 09. Feb, 2005 schwätzte Craig White so:
> 
> > previous in thread, you stated:
> >
> > 38400 works fine for reading from the DSL modem.
> 
> For reading, but apparently not for writing.
> 
> > I presume that means that you can get it login, so keyboard works and
> > you can issue commands such as 'show run' and 'write' and 'reboot'
> 
> It stalls before getting to the login prompt and asks me to hit <enter>,
> but doesn't respond when I do so.
> 
> > It's possible that a control - C break is swallowed/altered by com
> > program
> 
> That's what I thought, so I tried kermit after minicom didn't work then
> tried them both in an xterm w/o being in screen.
> 
> In all cases I powered off the DSL and restarted it to make sure it wasn't
> horked from the previous session.
> 
> I haven't ruled out that it's operator induced, but I think I'm doing
> things correctly.
----
according to
<http://home.visi.com/support/dsl/675/setup_hyper.html>

38400 8N1 is proper setting

it suggests that a single hit of the <ENTER> key should give you a login
prompt



<http://www.webguyinternet.com/dsl/CiscoSetup.pdf>

this web page has a method of doing a factory reset

Craig

---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss