Contents of the .bin file: > These are the commands I'm following: > > - > Tar jxfv konversation-1.3.1.tar.bz2 > ls > cd konversation-1.3.1 > ./configure > make > make install > vi INSTALL > - > > and nothing happens. Are you actually capitalizing the Tar command? Or was that just your editor that did that? That said, I went and grabbed a copy of the tarball. The commands listed above wouldn't work, since it doesn't have a configure script, and instead uses cmake. -- Dan. On Sat, Aug 14, 2010 at 9:50 AM, Eric - A <ericallen3@juno.com> wrote: > Hi all, I'm trying to learn how to use tarballs but I'm running into a dead-end with the commands I found on a couple of "how-to" pages. The commands I executed are attached and show the commands I used. Any help will do. > > > . > Eric - A > . > > ____________________________________________________________ > Notre Dame Certificates > 100% Online Programs in Negotiation Leadership and Mgmt. Enroll Today! > http://thirdpartyoffers.juno.com/TGL3141/4c66c9882a780756834st02vuc > --------------------------------------------------- > PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us > To subscribe, unsubscribe, or to change your mail settings: > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss > --------------------------------------------------- PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us To subscribe, unsubscribe, or to change your mail settings: http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss